TreoCentral.com - View Single Post

webtoker · 02/06/2005, 01:09 PM

----- This part is only done once ------

1. Reset the phone making sure nothing will start up a data connection (verichat / chatter)

2. Turn on DUN and Discoverable in the Bluetooth section of the Treo.

3. Discover the device in OS X. Make sure OS X sees that the phone is providing DUN services. If not reset the phone and try again.

4. Choose the generic edge modem scripts (Listed on the site above).

----- This section is used from this point on when wanting to use DUN ------

5. Open interconnnect and dial using the bluetooth connection with nothing set in user, pass, or numbder. (This may only be a At&t thing)

6. Bingo, you are connected.

I found that I can only connect once, then I have to turn the Treo bluetooth off and back on to connect again.

02/06/2005, 01:09 PM	#20 (permalink)
webtoker Member Join Date: Dec 2004 Posts: 126 Thanks: 0 Thanked 0 Times in 0 Posts	----- This part is only done once ------ 1. Reset the phone making sure nothing will start up a data connection (verichat / chatter) 2. Turn on DUN and Discoverable in the Bluetooth section of the Treo. 3. Discover the device in OS X. Make sure OS X sees that the phone is providing DUN services. If not reset the phone and try again. 4. Choose the generic edge modem scripts (Listed on the site above). ----- This section is used from this point on when wanting to use DUN ------ 5. Open interconnnect and dial using the bluetooth connection with nothing set in user, pass, or numbder. (This may only be a At&t thing) 6. Bingo, you are connected. I found that I can only connect once, then I have to turn the Treo bluetooth off and back on to connect again. Last edited by webtoker; 02/06/2005 at 01:19 PM.