you looking for the cheapest way to carry your Visor on your belt?
The Handspring Plastic Beltclip is a very economical way for you to be
able to always have you Visor "at the ready."
The Handspring Beltclip is a minimalist's case and is effectively a
holster for your Visor. When inserted, the entire face of the Visor
is protected. The top, bottom, and back of the Visor is completely
exposed. The Handspring logo is visible on the inside of the case
and on the beltclip itself. This case is Graphite and mostly plastic,
with only part of the beltclip made of metal.
is the first beltclip case that I have seen that allows you to have a non-standard
size Springboard module always at your side. I was able to insert
and remove the Handspring Modem with ease, even while the Visor was still
in the case. The only modules that will have a problem with this
case are ones that are completely flush with the Visor as the holster lips
over the top of the Visor by a few millimeters. There haven't been
any flush Springboard modules yet, so this isn't an issue. Besides,
I don't think anyone wants their oversize modules exposed anyway.
exposed is the major concern for this case. If a case could be considered
a suit for the Visor, than the Handspring Beltclip is the jockstrap of
cases. Like a jockstrap, it covers the front completely and leaves
the back almost completely exposed. Only the sides of the Visor below
the Springboard slot is covered to protect from accidental bumps against
objects. This protection is for the bottom only. Bump against
something with the top of the Visor, and you could be making a repair call
for your Visor. The Ir port is exposed, but since the screen is covered,
you wouldn't be able to effectively beam anyway. The HotSync port
is also exposed, but once again, you can't really use a cable HotSync when
you can't see the screen.